Web conference camera debugging tips

Web conference camera debugging tips

When the daily meeting wants the camera to quickly reach the required focus position, the meeting camera can be preset in advance in advance and the camera is set as follows:

one. How to set the address code, protocol, baud rate on the back of the camera, there are 3 above the title of the switch, the small white switch dialed above called "on" or called "open", otherwise called "off" or called "off "If you only use one camera (the same below), it is recommended that:

Switch the "1" switch of "SW1" to the position of "on", and dial "2" to "8" to the position of "off", indicating that the address of your camera is "1";

Turning the "SW2" "1" and "2" switches to the "off" position means that you can remotely control the camera without first pressing the address of the remote controller.

Switch the “3” switch of “SW2” to the “off” position, and the “4” dial to the position of “on” means the protocol of your camera is “PELCD_D”;

Turn the "5" and "6" switches of "SW2" to the "off" position, which means your camera's baud rate is 4800BPS.

Second, other points

1. After you set up or modify the settings, the power of the camera must be turned off. After a few seconds, the power supply will take effect. After the power is supplied, the camera will self-rotate for a while and wait for the camera to stop;

 2, each time you first use the remote control to remotely control the camera, you must first press the "1" key on the top of the remote control to control the camera (the position here, there are only three numbers from 1 to 3, instead of 1 under the remote control. The "1" to 9;

 3, if the image you see is reversed, you can flip the image by pressing "REV" in the middle of the remote controller.