Video Conversion Device Usage Precautions

Video conversion device usage precautions

Before the video converter device is powered on, it is necessary to check to ensure that the chassis is well grounded to prevent electrostatic discharge from the chassis and endanger the equipment and personal safety. It also has good shielding effect. Please observe the following when installing, using and maintaining.

Please note that the chassis is well grounded.

Ø Please use the single-phase three-wire AC 220V power supply with protective ground and ensure that the entire engineering system uses the same protection ground. The unprotected power supply cannot be used and the grounding pin of the power cord cannot be destroyed.

Ø When you need to move the equipment or other work that needs to be powered off, turn off all power, including the power switch, unplug the power plug, etc. to ensure the safety of you and the equipment. Note: When the weather is wet or wet, or when it is not used for a long time, the main power switch should be turned off.

Ø Do not press on the power cable, signal cable, communication cable, etc. Cables should be prevented from being stepped on or squeezed to prevent leakage or short circuit.

Ø When plugging in or unplugging the signal cable from the device, the device needs to be powered off to avoid damage to the device. Damage caused by hot plugging is not covered by the warranty.

Ø Equipment should be properly placed. The power supply of the equipment will generate heat when working. Therefore, it is necessary to keep the working environment well ventilated to avoid damage to the equipment due to excessive temperature. If it is installed in a standard rack, chassis, cabinet, or on a work surface of a stable platform, prevent the device from falling.

Ø The equipment should work in a dusty or moisture-proof environment. Do not place the system equipment in a place that is too cold or too hot.

Ø Take care to avoid liquid immersion and splashing into the interior of the device, especially to prevent chemicals or liquids from spilling on or near the device.

Ø All maintenance work should be completed by professional maintenance and repair personnel. Do not try to repair the equipment yourself without training to prevent electric shock hazard, so as to avoid accidents or increase the damage of equipment. USB capture card DVI capture card