The setting method of using wireless 4g live broadcast encoder
Jul 11, 2018
The setting method of using wireless 4g live broadcast encoder
4G Live Broadcast Encoder is a live broadcast encoder for high-definition video streaming through wireless 3G/4G network, Wifi network and wired network.
The following is a description of the common settings for the most popular wireless live broadcast encoders.
1.Use the card pin to remove the card holder of the live encoder, then put the 4G card into the card slot and reinsert it into the live encoder.
2.Connect the encoder to the signal source with an HDMI cable or SDI cable, and then connect the encoder to the computer. There are two ways to connect the 4G encoder to the computer. The first way is to connect the encoder directly to the computer with a network cable.
3.The second method is to wirelessly connect the 4G encoder to the wireless computer or notebook. Open the computer notebook, check the wireless connection of the notebook, find the wireless name of the 4G encoder "" click the connection, enter the password.
4.After connecting, open IE browser, enter the IP address (please consult the manual here), and then enter the user name and password to log in.
5.At this time, the operation page of the registered encoder is displayed.
6.However, I found an exclamation point on the wireless connection in the lower right corner. Clicking “Network Center and Sharing” will find that the computer is connected to the 4G encoder, but it is not connected to the Internet.
7.At this time, you must log in to the 4G router background: 192.168.0.1, enter the user name and password, and view the connection mode display: not connected. In this case, check if the 4G encoder 4G card is installed correctly and the antenna is installed correctly. Then restart the router and the connection is displayed.
8.Then go back to the background control page of the 4G encoder and set its parameters.
9.Mainstream encoding settings, if mainly used for RTMP push streaming, just enter the RTMP upload server address here, RTMP address of your live broadcast platform
10.Take the live broadcast of the network platform as an example, set up a live channel on the live broadcast platform, and then you can see a live push stream address, directly copy the address in the address to the RTMP upload server address bar.
11 Then copy the "watch" to the upload directory name.
12 Then copy "f32udp" to the "RMTP" upload node. Then click the disabled port of the upload server address and select "Enable" and then click Settings. After the setting is successful, click "Restart" device in the system settings.
